Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Interior / Power Outlets (int) / Voltage Inverter / Installation

INSTALLATION

PROCEDURE

1. INSTALL VOLTAGE INVERTER ASSEMBLY

(a) Install the voltage inverter with the 3 bolts.

Torque:

7.5 N·m {76 kgf·cm, 66 in·lbf}

(b) Connect the 2 connectors.

2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH

3. INSTALL FRONT DECK SIDE TRIM COVER RH

4. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

5. INSTALL REAR NO. 1 SEAT LAP BELT OUTER ANCHOR COVER

6. INSTALL REAR FLOOR CARPET ASSEMBLY (w/o Deck Board)

7. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

8. INSTALL NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Deck Board)

9. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM COVER (w/o Deck Board)

10. INSTALL DECK BOARD ASSEMBLY (w/ Deck Board)

11. INSTALL LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY RH (w/ Deck Board)

12. INSTALL LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY LH (w/ Deck Board)

13. INSTALL REAR NO. 2 FLOOR BOARD ASSEMBLY (w/ Deck Board)

14. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY (w/ Deck Board)

15. INSTALL NO. 2 LUGGAGE COMPARTMENT TRIM COVER (w/ Deck Board)

16. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH

17. INSTALL REAR DOOR SCUFF PLATE RH

18. INSTALL QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)

19. INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

Removal

REMOVAL PROCEDURE 1. REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat) 2. REMOVE QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat) 3. REMOVE REAR DOOR SCUFF PLATE RH 4. REMOVE REAR DOOR ...

Other materials about Toyota 4Runner:

Backup Battery Degradation (B15EC)
DESCRIPTION This DTC is stored when the DCM (Telematics Transceiver) detects either of the following conditions. The BUB (Back-Up Battery) charge level becomes less than the criteria. Automatic Collision Notification (ACN) was performed. ...

Crawl Indicator Light Remains ON
DESCRIPTION Refer to Crawl Indicator Light does not Come ON (See page ). WIRING DIAGRAM Refer to Crawl Indicator Light does not Come ON (See page ). CAUTION / NOTICE / HINT NOTICE: When replacing the master cylinder solenoid, perform calibration (See ...