Toyota 4Runner: Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 STEREO JACK ADAPTER ASSEMBLY
(a) Attach the 2 claws to install the No. 1 stereo jack adapter assembly.
2. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Climate Control Seat System)
.gif)
3. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/ Climate Control Seat System)
4. INSTALL NO. 2 CONSOLE BOX RETAINER
5. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for VF2A)
7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
8. INSTALL HEATER CONTROL ASSEMBLY
9. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
10. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
12. CHECK SRS WARNING LIGHT
(See page )
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS sys ...
Window Glass Antenna Wire
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WINDOW GLASS ANTENNA WIRE
(a) Check for continuity of the window glass antenna wire.
Text in Illustration
...
Other materials about Toyota 4Runner:
LVDS Signal Malfunction (from Extension Module) (B1532)
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
B1532
When one of the conditions below is met:
Stereo component tuner assembly is/was not connected while the
ignition sw ...
Invalid Data Received from Deceleration Sensor (C1442,C1443)
DESCRIPTION
The skid control ECU receives signals from the yaw rate and acceleration sensor
via the CAN communication system.
DTC Code
DTC Detection Condition
Trouble Area
C1442
An invalid data s ...
0.0081