Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Drivetrain / Axle And Differential / Rear Differential Carrier Assembly(w/ Differential Lock) / Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

(a) Remove any dust and oil from the differential carrier assembly and the contact surfaces of the axle housing.

(b) Install a new gasket and the differential carrier assembly with the 11 nuts and 11 washers.

Torque:

52 N·m {530 kgf·cm, 38 ft·lbf}

(d) Connect the rear differential lock actuator breather hose to the differential actuator assembly.

2. INSTALL REAR AXLE SHAFT LH

(a) Install the rear axle shaft LH (See page
).

3. INSTALL REAR AXLE SHAFT RH

HINT:

Use the same procedure described for the LH side.

4. INSTALL PROPELLER SHAFT ASSEMBLY

(a) Install the propeller shaft assembly (See page ).

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL DIFFERENTIAL CASE ASSEMBLY (a) Install the rear differential side gear thrust washer to the rear differential side gear. (b) Install the rear differential pinio ...

Rear Differential Carrier Assembly(w/o Differential Lock)

...

Other materials about Toyota 4Runner:

Compressor Lock Sensor Circuit (B1422)
SYSTEM DESCRIPTION The ECM sends the engine speed signal to the air conditioning amplifier assembly via CAN communication. The air conditioning amplifier assembly reads the difference between compressor speed and engine speed. When the difference becomes ...

Brake Warning Light does not Come ON
DESCRIPTION Refer to Brake Warning Light Remains ON (See page ). WIRING DIAGRAM Refer to Brake Warning Light Remains ON (See page ). CAUTION / NOTICE / HINT NOTICE: When replacing the master cylinder solenoid, perform calibration (See page ). PROC ...