Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Drivetrain / Drive Shaft / Propeller Shaft / Front Propeller Shaft Assembly / Installation

INSTALLATION

PROCEDURE

1. INSTALL FRONT PROPELLER SHAFT ASSEMBLY

(a) Align the matchmarks on the yoke and differential flange.

(b) Install the propeller shaft assembly with the 4 washers, 4 bolts and 4 nuts.

Torque:

88 N·m {899 kgf·cm, 65 ft·lbf}

(d) Install the propeller shaft assembly with the 4 washers and 4 nuts.

Torque:

88 N·m {899 kgf·cm, 65 ft·lbf}

2. INSTALL FRONT EXHAUST PIPE

(a) Install the front exhaust pipe (See page
).

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING HINT: Use the same procedure for all propeller shaft universal joint spider bearing. (a) Apply MP g ...

Propeller Shaft Assembly(for 2wd)

...

Other materials about Toyota 4Runner:

Dtc Check / Clear
DTC CHECK / CLEAR 1. DTC CHECK / CLEAR (when Using Techstream) (a) Check for DTCs. (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON. (3) Turn the Techstream on. (4) Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Cod ...

Turbine Speed Sensor Circuit No Signal (P0717)
DESCRIPTION This sensor detects the rotation speed of the turbine which indicates the input speed of the transmission. By comparing the input turbine speed signal NT with the counter gear speed sensor signal SP2, the ECM detects the shift timing of the ge ...