Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Drivetrain / Vf2a Transfer / 4wd / Awd / Transfer Assembly / Installation

INSTALLATION

PROCEDURE

1. INSTALL TRANSFER ASSEMBLY

(a) Install the transfer to the transmission.

(b) Install the 8 bolts.

Torque:

24 N·m {245 kgf·cm, 18 ft·lbf}

2. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

(a) Install the automatic transmission (See page ).

3. ADD TRANSFER OIL

4. CHECK FOR TRANSFER OIL LEAK

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL TRANSFER DRIVE SPROCKET SUB-ASSEMBLY Text in Illustration *1 Shifting Key *2 Drive Sprocket *3 ...

Transfer Case Front Oil Seal

Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT PROCEDURE 1. DRAIN TRANSFER OIL 2. REMOVE FRONT PROPELLER SHAFT ASSEMBLY (a) Remove the front propeller shaft (See page ). ...

Other materials about Toyota 4Runner:

System Description
SYSTEM DESCRIPTION 1. ENGINE IMMOBILISER SYSTEM DESCRIPTION (a) The engine immobiliser system determines whether or not to enable starting of the SFI system based on a comparison of the key ID code and the vehicle pre-registered code. The engine immobili ...

Power Supply Drive Circuit (C1257)
DESCRIPTION The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU. DTC Code DTC Detection Condition Trouble Area ...