Toyota 4Runner: Multi-terrain Select Indicator Light Remains ON
DESCRIPTION
Refer to Multi-terrain Select Indicator Light does not Come ON (See page
.gif)
).
WIRING DIAGRAM
Refer to Multi-terrain Select Indicator Light does not Come ON (See page
).
PROCEDURE
|
1. |
READ VALUE USING TECHSTREAM (OFF-ROAD GUIDANCE SWITCH (MULTI-TERRAIN SELECT SWITCH)) |
| OK | .gif) |
GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) |
| NG | |
REPLACE DRIVE MONITOR SWITCH |
Crawl Indicator Light does not Come ON
DESCRIPTION
If any of the following conditions are met, the crawl indicator light blinks
and crawl control is stopped.
Crawl control is operated when the vehicle stability control system
...
Multi-terrain Select Indicator Light does not Come ON
DESCRIPTION
When the ON/OFF switch of the multi-terrain select switch is turned on, multi-terrain
select control is enabled and the multi-terrain select indicator light illuminates.
After selectin ...
Other materials about Toyota 4Runner:
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR NO. 2 SEAT ASSEMBLY
(a) Remove the rear No. 2 seat assembly (See page
).
2. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER (w/o Deck Board)
3. REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Deck Board)
4. REMOVE NO. 2 LUG ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK POWER MANAGEMENT CONTROL ECU
(a) Disconnect the F80 power management control ECU connector.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
Terminal No. (Symbol)
Wirin ...
0.0078