Toyota 4Runner: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check (See page
.gif)
).
(b) With the front seat side airbag installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seat with a new one:
Cuts, minute cracks or marked discoloration on the front seatback around the front seat side airbag.
2. CHECK FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
(a) Perform a diagnostic system check (See page
).
(b) With the front seat side airbag removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seat side airbag with a new one:
- Cuts, minute cracks or marked discoloration on the front seat side airbag.
- Cracks or other damage to the wire harness or connector.
NOTICE:
For removal and installation of the front seat side airbag, be sure to follow the correct procedure.
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
Use the same procedure for the power seat RH and power seat LH ...
Other materials about Toyota 4Runner:
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CONNECT TECHSTREAM
(a) Connect the Techstream to the DLC3.
(b) Start the engine and run it at idle.
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
HINT:
Refer to the T ...
Slip Indicator Light does not Come ON
DESCRIPTION
Refer to Slip Indicator Light Remains ON (See page
).
WIRING DIAGRAM
Refer to Slip Indicator Light Remains ON (See page
).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the master cylinder solenoid, perform calibration (See page
).
PR ...
0.0273