Toyota 4Runner manuals

Toyota 4Runner: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT REAR WIPER MOTOR AND BRACKET ASSEMBLY

(a) Operate the rear wiper motor and bracket assembly.

(b) Stop the rear wiper motor and bracket assembly operation.

(c) Check the automatic stop position.

Components
COMPONENTS ILLUSTRATION ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. RE ...

Other materials about Toyota 4Runner:

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT AXLE HUB OIL SEAL LH (a) Using SST and a press, press in a new oil seal. SST: 09608-36010 SST: 09950-70010 09951-07100 NOTICE: Do not damage the oil seal. ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (Using SST Check Wire) (a) Check for DTCs (present trouble code). (1) Turn the ignition switch to ON and wait for approximately 60 seconds. (2) Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3. SST: 09843-18040 N ...

© 2016-2026 | www.to4runner.net

0.0104