Toyota 4Runner: On-vehicle Inspection

Toyota 4Runner Service Manual / Vehicle Interior / Heating / Air Conditioning / Condenser / On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT COOLER CONDENSER ASSEMBLY

(a) If the fins of the cooler condenser are dirty, clean them with water. Dry the fins with compressed air.

NOTICE:

Do not damage the fins of the condenser.

(b) If a fin of the cooler condenser is bent, straighten it using a screwdriver or pliers.

2. CHECK CONDENSER FOR LEAKAGE OF REFRIGERANT

(a) Using a halogen leak detector, check the pipe joints for gas leakage. If gas leakage from a joint is detected, check the torque of the joint.

Installation

INSTALLATION PROCEDURE 1. INSTALL COOLER DRYER (a) Using pliers, install the cooler dryer. (b) Apply a sufficient amount of compressor oil to the contact surfaces of a new O-ring an ...

Other materials about Toyota 4Runner:

Room Temperature Sensor
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE NO ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL STEERING RACK END SUB-ASSEMBLY (a) Temporarily install the 2 steering rack ends to the steering rack. (b) Fill up the ball joints of the steering rack ends with MP grease. (c) Using SST, install the steering rack ...