Toyota 4Runner: On-vehicle Inspection

Toyota 4Runner Service Manual / Vehicle Interior / Supplemental Restraint Systems / Knee Airbag Assembly(for Front Passenger Side) / On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. CHECK LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)

(a) Perform a diagnostic system check (See page ).

(b) With the lower No. 2 instrument panel airbag installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 2 instrument panel airbag with a new one:

Cuts, minute cracks or marked discoloration on the lower No. 2 instrument panel airbag.

2. CHECK LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

(a) Perform a diagnostic system check (See page ).

(b) With the lower No. 2 instrument panel airbag removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 2 instrument panel airbag with a new one:

Cuts, minute cracks or marked discoloration on the lower No. 2 instrument panel airbag.
Cracks or other damage to the connector.
Deformation or cracks in the instrument panel reinforcement.

CAUTION:

For removal and installation of the lower No. 2 instrument panel airbag, be sure to follow the correct procedure.

Installation

INSTALLATION PROCEDURE 1. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (a) Connect the connector. NOTICE: When handling the airbag connector, take care not to damage the ai ...

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS sys ...

Other materials about Toyota 4Runner:

Open or Short in Master Cylinder Pressure Sensor (C1421,C1281,C1423,C1424)
DESCRIPTION DTC Code DTC Detection Condition Trouble Area C1421 Either condition is met: Both of the following conditions continue for at least 1.2 seconds. The IG1 terminal volta ...

Disposal
DISPOSAL CAUTION / NOTICE / HINT HINT: The tire pressure warning valve and transmitter is powered by a lithium battery. When disposing of the tire pressure warning valve and transmitter, remove the battery and dispose of it properly. PROCEDURE 1. DISP ...