Toyota 4Runner: Precaution

CAUTION:

• Be sure to check the pipe connections and whether or not any hydraulic circuit parts are damaged before performing work as the hydraulic circuits become highly pressurized during air bleeding.
• The pipes become highly pressurized when bleeding air. If a fluid leak is discovered, immediately release the pressure and repair the fluid leak as there is danger involved.
• Do not disassemble the stabilizer control with accumulator housing assembly or expose it to an open flame as the accumulator of the stabilizer control with accumulator housing assembly contains gas.

NOTICE:

• Before removing or installing hydraulic circuit parts, clean each part to prevent mud and dirt from entering the hydraulic circuit.
• Always drain fluid from the bleeder plug of the stabilizer control with accumulator housing to reduce pressure before removing parts as the fluid is sealed under high pressure in the hydraulic circuit.
• Protect the removed parts with plastic bags to prevent foreign matter from adhering to or entering them, and store them in a safe place.
• Be careful when removing or installing the hydraulic circuit related parts, such as bleeder plugs and tube flare nuts, as fluid may leak when the parts are damaged.

Suspension Control System(w/ Kdss)

...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order ...

Other materials about Toyota 4Runner:

Receiver Error (C2176/76)
DESCRIPTION The signals are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU. DTC Code DTC Detection Condition Trouble Area ...

Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio and display receiver assembly via this circuit. The sound signal that has been sent is amplified by the radio and display receiver assembly and ...