Toyota 4Runner: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Axle System|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
Vehicle unstable |
Tire (Worn or improperly inflated) |
|
|
Wheel alignment (Incorrect) |
|
|
|
Steering linkage (Loosen or worn) |
- |
|
|
Hub bearing (Worn) for 2WD |
|
|
|
Hub bearing (Worn) for 4WD |
|
|
|
Steering gear (Out of adjustment or broken) |
- |
|
|
Suspension parts (Worn) |
- |
|
|
Front wheel shimmy |
Tire (Worn or improperly inflated) |
|
|
Wheel (Out of balance) |
|
|
|
Front shock absorber (Worn) |
|
|
|
Wheel alignment (Incorrect) |
|
|
|
Upper ball joint (Worn) |
|
|
|
Lower ball joint (Worn) |
|
|
|
Hub bearing (Worn) for 2WD |
|
|
|
Hub bearing (Worn) for 4WD |
|
|
|
Steering linkage (Loose or worn) |
- |
|
|
Rear wheel shimmy |
Tire (Worn or improperly inflated) |
|
|
Wheel (Out of balance) |
|
|
|
Rear shock absorber (Worn) w/ REAS |
|
|
|
Rear shock absorber (Worn) w/o REAS |
|
|
|
Rear axle shaft (Worn) |
|
.gif)
Axle System
...
Differential Oil
Replacement
REPLACEMENT
PROCEDURE
1. INSPECT DIFFERENTIAL OIL LEVEL
(a) Stop the vehicle on a level surface.
(b) Remove the differential filler plug and gasket.
(c) Check that the o ...
Other materials about Toyota 4Runner:
Portable Player cannot be Operated Using In-vehicle Device or Track Information
is not Displayed on In-vehicle Device
PROCEDURE
1.
CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL
(a) Check if track information is displayed normally on another "Bluetooth" audio
compatible vehicle of the same model.
...
Rear Differential Lock Control Switch
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT DIFFERENTIAL LOCK SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Switc ...
0.0263