Toyota 4Runner: Propeller Shaft System

Toyota 4Runner Service Manual / Drivetrain / Drive Shaft / Propeller Shaft / Propeller Shaft System

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

Propeller Shaft System

Symptom	Suspected Area	See page
Noise	Spider bearing (Worn or stuck) (2WD)
Noise	Spider bearing (Worn or stuck) (4WD)
Vibration	Propeller shaft (Runout) (2WD)
	Propeller shaft (Runout) (4WD)
	Propeller shaft (Imbalance)	-

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING HINT: Use the same procedure for all rear propeller shaft universal joint spider bearing. (a) Apply ...

Vf2a Transfer / 4wd / Awd

...

Other materials about Toyota 4Runner:

Steering Pad Switch Circuit
DESCRIPTION This circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly. If there is an open in the circuit, the radio system cannot be operated using the steering pad switch assembly. If there ...

Test Mode Procedure
TEST MODE PROCEDURE NOTICE: After replacing the master cylinder solenoid and/or yaw rate and acceleration sensor, perform calibration. VSC is prohibited during test mode. HINT: By switching the skid control ECU from normal mod ...