Toyota 4Runner: Reassembly

Toyota 4Runner Service Manual / Vehicle Exterior / Mirror (ext) / Outer Rear View Mirror / Reassembly

REASSEMBLY

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL OUTER MIRROR LIGHT ASSEMBLY BULB (w/ Side Turn Signal Light)

(a) Install the outer mirror light assembly bulb.

2. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH (w/ Side Turn Signal Light)

3. INSTALL OUTER MIRROR COVER LH

(a) Attach the 7 claws to install the outer mirror cover LH.

4. INSTALL OUTER MIRROR HOLE COVER LH

(a) Attach the 5 claws to install the outer mirror hole cover LH.

5. INSTALL OUTER MIRROR LH

(a) Connect the connector.

(b) Attach the 4 claws to install the outer mirror LH.

Inspection

INSPECTION PROCEDURE 1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH (w/ Side Turn Signal Light) (a) Apply battery voltage and check the operation of the outer mirror LH. OK: ...

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL OUTER REAR VI ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION PROCEDURE 1. INSTALL STABILIZER CONTROL WITH ACCUMULATOR HOUSING ASSEMBLY (a) Install the stabilizer control with accumulator housing with the 3 bolts. Torque: 29 N·m {296 kgf·cm, 21 ft·lbf} (b) Connect the connector, and then attach the ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP (a) Hold the drive shaft lightly in a vise between aluminum plates. (b) Using pliers, remove the front No. 2 axle inboard joint boot clamp as shown in the illustration ...