Toyota 4Runner: Reassembly

Toyota 4Runner Service Manual / Brake / Brake System (other) / Brake Master Cylinder / Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL MASTER CYLINDER RESERVOIR GROMMET

(a) Apply a light coat of lithium soap base glycol grease to 2 new master cylinder reservoir grommets.

(b) Install the 2 master cylinder reservoir grommets to the brake master cylinder reservoir assembly.

2. INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY

(a) Install the brake master cylinder reservoir assembly to the brake master cylinder body.

(b) Using a pin punch and hammer, install a new pin to the brake master cylinder reservoir assembly.

3. INSTALL BRAKE MASTER CYLINDER RESERVOIR STRAINER

4. INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY

5. INSTALL BRAKE FLUID INFORMATION LABEL

Inspection

INSPECTION CAUTION / NOTICE / HINT NOTICE: The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure the tip of the master cylinder ...

Installation

INSTALLATION CAUTION / NOTICE / HINT PROCEDURE 1. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY (a) Install a new O-ring to the brake master cylinder sub-assembly. (b) Install the brake master cylin ...

Other materials about Toyota 4Runner:

Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: Be sure to read PRECAUTION before performing this procedure (See page ). PROCEDURE 1. REMOVE FRONT WHEEL 2. REMOVE REAR WHEEL 3. REMOVE CENTER CONTROL ABSORBER ASSEMBLY LH (a) While using a wrench to ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE LOWER STEERING COLUMN COVER (a) Turn the st ...