SYSTEM DESCRIPTION
1. GENERAL
(a) The heater and blower both have 3 levels controlled by operating the dial-type refreshing seat switch, which is located in the upper console panel.
(b) The on/off state of the heater or blower can be determined by checking if the refreshing seat switch indicator light is on or off.
(c) The blowers of both seats are controlled by the air conditioning amplifier assembly.
(d) The seat heaters of both seats are controlled by the seat heater controls, which are located under their respective seats.
Back Camera Disconnected (C1622)
DESCRIPTION
This DTC is stored if the navigation receiver assembly judges that the signals
or signal lines between the navigation receiver assembly, and the rear television
camera assembly are not normal as a result of its self check.
DTC No.
...
Short to GND in CAN Bus Line
DESCRIPTION
There may be a short circuit between the CAN bus lines and GND when the resistance
between terminals 6 (CANH) and 4 (CG) or terminals 14 (CANL) and 4 (CG) of the DLC3
is below 200 Ω.
Symptom
Trouble Area
...