Toyota 4Runner: Components

Rear Door Belt Moulding

...

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE ...

Other materials about Toyota 4Runner:

TC and CG Terminal Circuit
DESCRIPTION DTC output mode is set by connecting terminals TC and CG of the DLC3. WIRING DIAGRAM HINT: When each warning light continues blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspec ...

Inspection
INSPECTION PROCEDURE 1. INSPECT PROPELLER SHAFT ASSEMBLY (a) Using a dial indicator, check the propeller shaft runout. Maximum runout: 0.4 mm (0.0157 in.) If the shaft runout is more than the maximum, replace the shaft. ...