Toyota 4Runner: Dtc Check / Clear
DTC CHECK / CLEAR
1. DTC CHECK/CLEAR (Using the Techstream)
(a) Check DTC:
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Enter the following menus: Body Electrical / Telematics / Trouble Codes.
(5) Check the DTCs.
(b) Clear DTC:
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Enter the following menus: Body Electrical / Telematics / Trouble Codes.
(5) Clear the DTCs.
Diagnosis System
DIAGNOSIS SYSTEM
1. CHECK DLC3
(a) Check the DLC3 (See page ).
2. CHECK INDICATOR
(a) When a malfunction is detected in the Safety Connect system, the manual (SOS)
switch red indicator on the m ...
Prl Update
PRL UPDATE
1. PRL UPDATE
This function updates the PRL (Preferred Roaming List) of the DCM (Telematics
Transceiver). The PRL is a large set of phone numbers the DCM (Telematics Transceiver)
can ...
Other materials about Toyota 4Runner:
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)
(a) Disconnect the S10 sliding roof drive gear sub-assembly connector.
(b) Measure the resistance and voltage according to the value(s) in the table
below.
HINT:
Measure ...
Washer Fluid Level Warning Switch Circuit
DESCRIPTION
When the volume of washer fluid decreases to below a certain level (when the
level warning switch is turned on), the multi-information display in the combination
meter assembly displays "LOW WASHER FLUID" to warn the driver.
WIRING ...
0.0066