Toyota 4Runner: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (See
page .gif)
).
PROCEDURE
1. INSTALL PINTLE HOOK SUPPORT TUBE SUB-ASSEMBLY (w/ Pintle Hook)
2. INSTALL REAR BUMPER UPPER RETAINER LH
3. INSTALL REAR BUMPER UPPER RETAINER RH
HINT:
Use the same procedure as for the LH side.
4. INSTALL REAR COMBINATION LIGHT LENS AND BODY LH
5. INSTALL REAR COMBINATION LIGHT LENS AND BODY RH
HINT:
Use the same procedure as for the LH side.
6. INSTALL REAR BUMPER SIDE SUPPORT LH
7. INSTALL REAR BUMPER SIDE SUPPORT RH
HINT:
Use the same procedure as for the LH side.
8. INSTALL REAR BUMPER BAR REINFORCEMENT LH
(a) Install the rear bumper bar reinforcement LH with the 2 bolts.
9. INSTALL REAR BUMPER BAR REINFORCEMENT RH
HINT:
Use the same procedure as for the LH side.
10. INSTALL REAR BUMPER ENERGY ABSORBER
11. INSTALL REAR BUMPER COVER
(a) Connect the connector.
(b) Attach the 18 claws to install the rear bumper cover.
(c) Install the 8 bolts and 4 screws.
12. INSTALL REAR QUARTER PANEL MUDGUARD LH
13. INSTALL REAR QUARTER PANEL MUDGUARD RH
HINT:
Use the same procedure as for the LH side.
14. INSTALL JACK BOX HOLE COVER
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER
2. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER
3. INSTALL ULTRASONIC SENSOR CLIP
4. INSTALL NO. 1 ULTRASONIC SENSOR
5. I ...
Other materials about Toyota 4Runner:
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...
Voice Recognition Microphone Disconnected (B1579)
DESCRIPTION
The navigation receiver assembly and map light assembly (telephone microphone
assembly) are connected to each other using the microphone connection detection
signal lines.
This DTC is stored when a microphone connection detection signal line ...
0.0068