Toyota 4Runner: Rear Bumper(w/ Intuitive Parking Assist System)

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL PINTLE HOOK SUPPORT TUBE SUB-ASSEMBLY (w/ ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota 4Runner:

System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Main Body ECU (Multiplex Network Body ECU) Sliding Roof Drive Gear Sub-assembly (Sliding Roof ECU) I ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FRONT SUSPENSION UPPER ARM BUSH LH HINT: Use the same procedure for the front and rear sides. (a) Using a hammer and chisel, strike and bend the entire flange of the upper arm bush as shown in the illustratio ...