Toyota 4Runner: Oil Pump

Removal

REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 2. REMOVE REAR ENGINE UNDER COVER ASSEMBLY 3. REMOVE FRONT FENDER APRON SEAL RH 4. REMOVE FRONT NO. 1 FENDER APRON TO FR ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota 4Runner:

Inspection
INSPECTION PROCEDURE 1. INSPECT TIE ROD END SUB-ASSEMBLY (a) Install the nut. (b) Flip the ball joint stud back and forth 5 times as shown in the illustration. (c) Using a torque wrench, turn the nut co ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE ROCKER PANEL MOULDING (w/ Intuitive Parking Assist System) (See page ) 2. REMOVE ...