Toyota 4Runner: On-vehicle Inspection

Toyota 4Runner Service Manual / Vehicle Interior / Supplemental Restraint Systems / Front Passenger Airbag Assembly / On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. CHECK INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)

(a) Perform a diagnostic system check (See page ).

(b) With the instrument panel passenger airbag installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the instrument panel passenger airbag with a new one:

Cuts, minute cracks or marked discoloration on the instrument panel passenger airbag.

2. CHECK INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

(a) Perform a diagnostic system check (See page ).

(b) With the instrument panel passenger airbag removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the instrument panel passenger airbag with a new one:

Cuts, minute cracks or marked discoloration on the instrument panel passenger airbag.
Cracks or other damage to the connector.
Deformation or cracks in the instrument panel reinforcement.

CAUTION:

For removal and installation of the instrument panel passenger airbag, be sure to follow the correct procedure.

Installation

INSTALLATION PROCEDURE 1. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (a) Attach the 5 hooks (A). Text in Illustration *a Hook A ...

Removal

REMOVAL PROCEDURE 1. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY (a) Remove the instrument panel sub-assembly (See page ). 2. REMOVE NO. 2 INSTRUMENT PANEL WIRE (a) Detach the clamp. ...

Other materials about Toyota 4Runner:

Removal
REMOVAL PROCEDURE 1. REMOVE DOOR SCUFF PLATE ASSEMBLY LH 2. REMOVE COWL SIDE TRIM BOARD LH 3. REMOVE NO. 2 SWITCH HOLE BASE 4. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH 5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY ...

Electrical Key Oscillator(for Outside Luggage Compartment)
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL ELECTRICAL KEY ANTENNA (a) Install the electrical key antenna with the bolt. Torque: 8.0 N·m {82 kgf·cm, 71 in·lbf} ...