Toyota 4Runner: Precaution
PRECAUTION
1. EXPRESSIONS OF IGNITION SWITCH
The type of ignition switch used on this model differs according to the specifications of the vehicle.
The expressions listed in the table below are used in this section.
|
Expression |
Ignition Switch (Position) |
Engine Switch (Condition) |
|---|---|---|
|
Ignition Switch off |
LOCK |
Off (Lock) |
|
Ignition Switch ACC |
ACC |
On (ACC) |
|
Ignition Switch ON |
ON |
On (IG) |
|
Engine Start |
START |
On (Start) |
2. HANDLING PRECAUTIONS FOR STEERING SYSTEM
(a) Care must be taken when replacing parts. Incorrect replacement could affect the performance of the steering system and result in driving hazards.
(b) Complete the adjustment of the steering wheel and wheel alignment, and then initialize the steering angle sensor. If the order is reversed, the steering wheel and wheel alignment will become misaligned.
3. HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM
(a) The vehicle is equipped with a Supplemental Restraint System (SRS). Failure
to carry out service operations in the correct sequence could cause the SRS to unexpectedly
deploy during servicing, possibly leading to a serious accident. Before servicing
(including removal/installation, inspection and replacement of parts), be sure to
read the precautionary notices for the supplemental restraint system (See page
.gif)
).
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
...
Other materials about Toyota 4Runner:
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY
(a) Using a dial indicator, measure the inside diameter of the oil pump
body bush.
Maximum inside diameter:
38.188 mm (1.50 in.)
If the inside diameter is m ...
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL
2. REMOVE FRONT FENDER MUDGUARD LH (w/o Intuitive Parking Assist System)
3. REMOVE ROCKER PANEL MOULDING COVER LH (w/o Intuitive Parking Assist System)
4. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH (w/o Intu ...
0.023