Toyota 4Runner: Theft Deterrent System Presence Detection (B279C)

Toyota 4Runner Service Manual / Vehicle Interior / Theft Deterrent / Keyless Entry / Engine Immobiliser System(w/ Smart Key System) / Theft Deterrent System Presence Detection (B279C)

DESCRIPTION

If an ECM that is incompatible with the engine immobiliser system is installed, the ECM stores this DTC.

DTC Code	DTC Detection Condition	Trouble Area
B279C	An ECM that is incompatible with the engine immobiliser system is installed.	ECM

PROCEDURE

1.	REPLACE CURRENT ECM WITH PROPER ECM

(a) Replace the current ECM with the proper ECM (See page ).

END

Theft Deterrent System Communication Line High Fixation (B279A)

DESCRIPTION If the communication line (EFIO-IMI) to the ID code box is stuck on HI output, the ECM stores this DTC. DTC Code DTC Detection Condition Trouble Area ...

Short to GND in Immobiliser System Power Source Circuit (B278A)

DESCRIPTION This DTC is stored when the engine switch power source supply line is open or shorted. DTC Code DTC Detection Condition Trouble Area B ...

Other materials about Toyota 4Runner:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT WHEEL 2. DRAIN BRAKE FLUID NOTICE: Wash off the brake fluid immediately if ...

Zero Point Calibration of Acceleration Sensor Undone (C1879/79)
DESCRIPTION The stabilizer control ECU receives the yaw rate and acceleration sensor zero point information from the skid control ECU via CAN communication. DTC Code DTC Detection Condition Trouble Area C18 ...