Toyota 4Runner: Inspection

Toyota 4Runner Service Manual / Vehicle Exterior / Wiper / Washer / Rear Wiper Motor / Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR WIPER MOTOR AND BRACKET ASSEMBLY

(a) Check the wiper intermittent operation.

(1) Connect the positive (+) lead of the battery to terminal 5 (L) and the negative (-) lead to terminal 4 (E), and check that the motor operates.

OK:

Motor operates.

Text in Illustration

*1	Component without harness connected (Rear Wiper Motor and Bracket Assembly)

If the result is not as specified, replace the rear wiper motor and bracket assembly.

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. RE ...

Installation

INSTALLATION PROCEDURE 1. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY (a) Attach the 2 guides and temporally install the rear wiper motor and bracket assembly with the 3 bolts. ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 OIL COOLER TUBE SUB-ASSEMBLY (a) Temporarily install the oil cooler tube to the fan shroud with bolt A. Install bolt B and tighten it to the specified torque. Then tighten bolt A to the specified to ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT SHOCK ABSORBER BUSH (a) Using SST and a press, install a new absorber bush. SST: 09710-30012 09710-04071 09710-04081 2. INSTALL FRONT COIL SPRING LH ...