Toyota 4Runner: Inspection

Toyota 4Runner Service Manual / Drivetrain / Axle And Differential / Rear Differential Carrier Assembly(w/o Differential Lock) / Inspection

INSPECTION

PROCEDURE

1. INSPECT DIFFERENTIAL PINION AND SIDE GEAR

(a) Check that there is no damage to the differential pinion or differential side gear.

If the differential pinion and/or differential side gear is damaged, replace the differential.

2. INSPECT DIFFERENTIAL CASE

(a) Check that the differential case is not damaged.

If the differential case is damaged, replace it.

Disassembly

DISASSEMBLY PROCEDURE 1. FIX REAR DIFFERENTIAL CARRIER ASSEMBLY IN PLACE 2. INSPECT RUNOUT OF REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY REAR (a) Using a dial indicator, measure the runou ...

Reassembly

REASSEMBLY PROCEDURE 1. ASSEMBLE DIFFERENTIAL CASE (a) Install the rear differential side gear thrust washer to the rear differential side gear. (b) Install the rear differential pinion thrust ...

Other materials about Toyota 4Runner:

Acceleration Sensor Internal Circuit (C1419,C1435)
DESCRIPTION The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system. The yaw rate and acceleration sensor has a built-in acceleration sensor and detects the vehicle condition using 2 circuits (GL1, ...

TC and CG Terminal Circuit
DESCRIPTION DTC output mode is set by connecting terminals TC and CG of the DLC3. WIRING DIAGRAM HINT: When each warning light continues blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspec ...