Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Drivetrain / Axle And Differential / Rear Differential Carrier Assembly(w/o Differential Lock) / Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

(a) Install a new gasket and the differential carrier assembly with the 10 nuts and 10 washers.

Torque:

52 N·m {530 kgf·cm, 38 ft·lbf}

2. INSTALL REAR AXLE SHAFT LH

(a) Install the rear axle shaft LH (See page
).

3. INSTALL REAR AXLE SHAFT RH

HINT:

Use the same procedure described for the LH side.

4. INSTALL PROPELLER SHAFT ASSEMBLY

(a) Install the propeller shaft assembly (See page ).

Reassembly

REASSEMBLY PROCEDURE 1. ASSEMBLE DIFFERENTIAL CASE (a) Install the rear differential side gear thrust washer to the rear differential side gear. (b) Install the rear differential pinion thrust ...

Rear Differential Carrier Oil Seal

...

Other materials about Toyota 4Runner:

Installation
INSTALLATION PROCEDURE 1. INSTALL BRAKE ACTUATOR BOLT CUSHION (a) Install the 3 brake actuator bolt cushions to the brake actuator bracket. 2. INSTALL BRAKE ACTUATOR CASE COLLAR (a) Install the 3 brake actuator case collars to the brake actuator bolt cush ...

Short to GND in Hall Effect Sensor Power Circuit (31)
DESCRIPTION When there is a short to GND in the side auto step motor hall sensor power circuit, the side auto step controller ECU assembly does not operate the automatic running board. DTC No. Detection Condition Trouble ...