Toyota 4Runner: Automatic Transmission System
Toyota 4Runner Service Manual / Drivetrain / A750e Automatic Transmission / Transaxle / Automatic Transmission System
- Precaution
- Definition Of Terms
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Road Test
- Mechanical System Tests
- Hydraulic Test
- Manual Shifting Test
- Initialization
- Monitor Drive Pattern
- Problem Symptoms Table
- Terminals Of Ecm
- Diagnosis System
- Dtc Check / Clear
- Check Mode Procedure
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Torque Converter Clutch Pressure Control Solenoid Control Circuit Electrical (Shift Solenoid Valve SLU) (P2759)
- Torque Converter Clutch Pressure Control Solenoid Performance (Shift Solenoid Valve SLU) (P2757)
- Transmission Fluid Temperature Sensor "B" Circuit Low Input (P2742,P2743)
- Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT) (P2716)
- Pressure Control Solenoid "D" Performance (Shift Solenoid Valve SLT) (P2714)
- Shift Solenoid "E" Control Circuit Low (Shift Solenoid Valve SR) (P0985,P0986)
- Shift Solenoid "B" Control Circuit Low (Shift Solenoid Valve S2) (P0976,P0977)
- 1-2 Shift (1-2 Shift Valve) (P0781)
- Pressure Control Solenoid "B" Electrical (Shift Solenoid Valve SL2) (P0778)
- Pressure Control Solenoid "B" Performance (Shift Solenoid Valve SL2) (P0776)
- Pressure Control Solenoid "A" Electrical (Shift Solenoid Valve SL1) (P0748)
- Output Speed Sensor Circuit No Signal (P0722)
- Turbine Speed Sensor Circuit No Signal (P0717)
- Transmission Fluid Temperature Sensor "A" Circuit Low Input (P0712,P0713)
- Transmission Range Sensor Circuit Malfunction (PRNDL Input) (P0705)
- Pressure Control Solenoid "A" Performance (Shift Solenoid Valve SL1) (P0746,P0771)
- Transmission Fluid Temperature Sensor "A" Performance (P0711)
- Transmission Control Switch Circuit
Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
NOTICE:
This transmission requires Toyota Genuine ATF WS.
After servicing the transmission, you must follow the ATF adjustment
procedure.
Ma ...
Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSION
HINT:
The type of ignition switch used on this model differs depending on the specifications
of the vehicle. The expressions listed in the table below are ...
Other materials about Toyota 4Runner:
Installation
INSTALLATION
CAUTION / NOTICE / HINT
PROCEDURE
1. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
(a) Install a new O-ring to the brake master cylinder sub-assembly.
(b) Install the brake master cylinder sub-assembly with 2 nuts.
Torque:
13 N·m {127 kgf·c ...
Engine Speed Signal Error (Test Mode DTC) (C2194/94)
DESCRIPTION
The tire pressure warning ECU receives an engine speed signal from the ECM. This
DTC is stored upon entering test mode and cleared when an engine speed signal of
1000 rpm is detected for 3 seconds or more. This DTC is stored only in test mode. ...
© 2016-2021 | www.to4runner.net
0.0063
0.0063