Toyota 4Runner: Steering Lock System
- Precaution
- Parts Location
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- IG2 Signal Malfunction (B2788)
- Power Source Control ECU Malfunction (B2782)
- Open / Short in Steering Lock ECU (B2781)
- Unable to Lock Steering Wheel
- Unable to Unlock Steering Wheel (Engine cannot Start)
Installation
INSTALLATION
PROCEDURE
1. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
(a) Align the matchmarks on the No. 2 steering intermediate shaft and power steering
gear.
(b) Install the bolt.
...
Precaution
PRECAUTION
1. PRECAUTIONS WHEN WORKING ON ELECTRIC STEERING LOCK
(a) After replacing the steering lock actuator assembly (steering lock ECU),
perform key ID code registration.
(b) After replacing ...
Other materials about Toyota 4Runner:
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT VOLTAGE INVERTER ASSEMBLY
HINT:
Remove interior parts so that the voltage inverter can be seen.
(a) Disconnect the voltage inverter connector.
(b) Measur ...
Rear Lower Arm
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL
2. DISCONNECT NO. 3 ...
© 2016-2026 | www.to4runner.net
0.0098
0.0098